The GeekVape Loop RDA V1.5 is a 24mm RDA (Rebuildable Dripping Atomiser). Recommended for advanced users it combines an innovative build deck with adjustable airflow and a stainless steel construction. It's compatible with a range of vape mods, including bottom feeding devices.
Quality machining and materials feature throughout, allowing the Loop V1.5 to be disassembled and reassembled with ease. This quality extends all the way to the gold-plated 510 connection which allows for increased heat conductivity and a faster ramp up.
The Loop V1.5 features a postless build deck that has a unique 'w' design, compatible with both single coil and dual coil builds. The diagonal orientation and 'sieve' design reduces spit back but also allow for a greater flow of air. The raised nature of the deck also leaves room for an ample size juice well.
Dual adjustable airflow allows for a greater degree of control over your inhale, with the grated cut-outs allowing you to find a balance between a breezy direct to lung vape or a more restricted one. This is mid airflow so you'll still be able to produce large clouds, but without sacrificing flavour.
Compatible with a range of vape mods, the Loop arrives prefitted with a standard 510 pin. There is a BF (Bottom Feeding) Pin included as well, that when installed make the Loop a squonk compatible RDA. Allowing it to be used with a range of bottom feeding devices; with the eliquid splitter under the deck allowing for consistent wicking.
- 1 x Geekvape Loop V1.5 RDA
- 1 x 810 Delrin Drip Tip
- 1 x 510 Drip Tip Adapter
- 1 x 510 Drip Tip
- 1 x BF Pin
- 1 x 510 Pin (preinstalled)
- 1 x Spares Kit
- 1 x User Manual
- 24mm diameter
- Adjustable middle airflow
- Postless build deck
- Supports single and dual coil builds
- Squonk compatible
- Can be used with a range of vape devices
Important information about Rebuildable Dripping Atomisers:
This product is designed for experienced users, and for those possessing an ohms reader or multimeter to test their coils on. This device requires a comprehensive understanding of the technicalities of vaping, along with knowledge of electronics and Ohm’s law.
We don't advise any beginners to start rebuilding coils without speaking to a knowledgeable shop. A rebuildable coil must be tested carefully on an Ohms Reader before it is used on a device. Not testing this properly may present a safety risk for the user, and no new coils should be used on an electronic vaping device until the coil is known to be safe.