The Innokin SlipStream replacement coils have been designed for their Slipstream vape tank. Recommended for sub ohm vaping, they should be paired with e-liquids above 60% VG.
Featuring a bottom vertical coil that funnels air from the top of the coil down, the SlipStream coils are leak resistant.
Available as a Stainless Steel 0.5 Ohm coil, that can be used in Temperature Control and Variable Wattage mode; or as a 0.8 Ohm Kanthal coil that can be used in Variable Wattage mode only. Both versions of the SlipStream replacement vape coils offer a balance of cloud and flavour production.
Important information about Sub Ohm Vaping:
Any coil that registers below 1.0 Ohm, is known as a sub ohm coil. Recommended for advanced vapers only, they'll require more power to use properly, which will be provided by an advanced vape kit.
With these coils larger amounts of vapour will be created, to support this we recommend you use e-liquids that are 60% VG or higher. Due to the larger amounts of vapour that is created, we advise that you do not use an e-liquid that has higher than a 6mg nicotine strength.
Registered members earn £0.50 in loyalty points for every published product review!
I bought the 0.5 and 0.8. Make sure you have temp control for the 0.5 coils. Used on a Kebor 50w, the 0.8 at 25w worked well. Didn't make the right choice of juice though, went for a 90% vg and I burnt two coils in three days... I'm putting that down to user error for too thick a juice. Will be trying some 50/50 next. I did get some spitting, possibly from flooding the coil?
By LoudWhisper from West Midlands
If you're looking for something a little more discreet - this is what you need. Nice little tank (the slipstream) and these coils are on point. Would recommend
By Tush from Bristol, UK
These coils do the job for the slipstream tank, easy to swap out when needed. Using Innokin Kroma.
These coils are great, leak proof and produce good clouds and flavour