£9.99
The Smok V12 Prince Mesh Coils have been designed for use with the Smok TFV12 Prince Tank.
Features:
Featuring a mesh coil rather than standard wound coil wire, a greater surface area is created allowing for not only increased flavour but also improved cloud production.
With a 0.15 Ohm resistance, these vape coils have been designed for sub ohm vaping. We recommend using high VG eliquids of 60% and above.
Contains:
Important information about Sub Ohm Vaping:
Any coil that registers below 1.0 Ohm, is known as a sub ohm coil. Recommended for advanced vapers only, they’ll require more power to use properly, which will be provided by an advanced vape kit.
With these coils larger amounts of vapour will be created, to support this we recommend you use e-liquids that are 60% VG or higher. Due to the larger amounts of vapour that is created, we advise that you do not use an e-liquid that has higher than a 6mg nicotine strength.
Do you have a question about this product? Why not ask our expert team.
Registered members earn £0.50 in loyalty points for every published product review!
By Nick from Woking
Thank god for these new mesh coils, they last 4 times longer than their original ones. Good flavour too!
By Joshua from Glasgow
10/10 great mesh coils, fast ramp up, great flavour, no spitting, and large clouds.
By Nick1995 from Plymouth
I've been using Smok products since I've started vaping and tried a rang of their coils and these are the best so far! Great taste and clouds! Last longer than any of the other coils I've used as well, usually last around 7/9 days sometimes longer!
By Martin
I get great flavour from these coils and fantastic clouds.
By Jtaylor19 from Essex
Used the dual coil before these, and obviously the dual were better, but these are not far off! The flavour is good and I’ve had mine in for over a week and still going well.
By Richard from Tyne Valley
I see what folks are saying about short life & inconsistency. I would recommend trying the Smok P-Tank alternatives. I've been using the 0.2ohm dual mesh option in my Prince tank. First thing I noticed was the improved flavour. More important perhaps is that I'm getting around 2 weeks from each use. And another week after a soak in alcohol, wash out & air dry. Also, please note, I always try a pierce coil cotton gently with a narrow needle. You can't do this with all coils as it depends on their construction. of course, do prime coils with juice & let them sit a few minutes before use. Start at around 35/40 watts & ramp up gradually to your desired wattage. Finally, ignore Smok's suggested wattages - they're way too high & can shorten coil life!! Hope this helps.
By Jamten from Southampton
I have tried a range of the coils. They all produce great flavour and cloud. However, they are so unreliable. The amount of coils which have burnt out in 2 to 3 days is ridiculous. I have wasted so much money on them. Any fruity flavour is an instant burn out, even at lower temperatures. I have decided to change tanks as I am so fed up
By Andrew from Dundee, Scotland
Early thoughts, fantastic flavour and cloud at a lower wattage. Now 3 days in on first coil. Unfortunately with smok, as i have found, coils are extremely inconsistent, but so far so good. Smok need better quality control on coils. Am currently cutting back and replacing a couple of tanks with uwell valyrian, however will buy these again.
By Geoh96 from Lancashire
I've used this coil for the past 4 days and I'm very impressed with it. The flavour in my opinion is much more prominent than that of the m4. From my experience with the mesh coils so far I would highly recommend. However only time will tell how long the coil will last.
By Adam from London
I have to disagree with the other review. I find these coils last at least 1300 puffs or more, and produce a great flavor from Wicks Boulevard. Much more so then the other Prince coils vaping @ 60w.