The Smok TFV16 Lite replacement vape coils have been designed for use with the Smok TFV16 Lite vape tank only. There are two versions of this coil available; a 0.2 Ohm conical mesh coil as well as a 0.15 Ohm dual mesh variant.
Due to the enhanced wicking ability and mesh construction, these coils provide clear flavour along with large cloud production. We recommend pairing with high VG e-liquids of 60% and above for best performance.
Important information about sub ohm vaping:
Any coil that registers below 1.0 Ohm, is known as a sub ohm coil. Recommended for advanced vapers only, they’ll require more power to use properly, which will be provided by an advanced vape kit.
With these coils larger amounts of vapour will be created, to support this we recommend you use e-liquids that are 60% VG or higher. Due to the larger amounts of vapour that is created, we advise that you do not use an e-liquid that has higher than a 6mg nicotine strength.
Do you have a question about this product? Why not ask our expert team.
Registered members earn £0.50 in loyalty points for every published product review!
One of the coils out of the 3 was really dodgy but luckily the other 2 were fine. They last me like 3 or 4 weeks and produce good flavour and smoke! I still prefer the other TFV16 lite coils but these do the job just fine
There is not enough cotton in these coils so they can’t hold the juice. It leaks from the cotton down into the base and out of the air holes all day long. My hands get covered in juice every time I pick up my vape. I have to clean everything every time I use it which is extremely frustrating. Will be changing tanks once I’ve used up all the coils I have for this.
I bought the 0.15 ohm pack and vape them at around 70 watts
They're great on flavor but so far they've dumped about 3 quarters of the liquid I've used in the tank.
If you've got money to burn on e liquid and a large pack of tissues to hand, these are good coils.
If you just wanna vape without cleaning up spills every half hour, these aren't for you.
By Gaz from England
The coil itself just does not seem to burn out. I‘ve had mine in for about 6 weeks now! HOWEVER - it leaks from the bottom seal, at least twice a day. I‘ve tried loosely fitting it, Mong strength tight and everything in between. It seems fine for a while until i go to use it and end up with my hand, mod and pocket covered in e-liquid.
If you don’t mind getting covered in liquid daily, then this Coil is great as they pretty much last forever.
By Gaz from UK
Now these little things don’t seem to burn out. I use it on 70 - 80 Watts and have had the thing in about a month now, no change in the coil at all!
Conical Mesh 0.2ohms
I like the mesh cone shaped Coil you get more air going through!
Doesn’t use to much eliquid
70 to 75 watts works well