The Smok V8-X4 Replacement vape coils are designed for use with the Smok TFV8 Cloud Beast tank. With the ability to create large amounts of vapour, these Smok coils should be paired with high VG e-liquids that are 60% VG or higher.
Featuring patented quadruple coils which provide large clouds, these Stainless constructed coils are also compatible with Temperate Control mode.
A quadruple coil build in each V8-X4 Smok coil means that you'll experience increased cloud and flavour production. Featuring a 0.15 Ohm resistance it can be used with a wattage range between 60W-150W.
Important information about Sub Ohm Vaping:
Any coil that registers below 1.0 Ohm, is known as a sub ohm coil. Recommended for advanced vapers only, they'll require more power to use properly, which will be provided by an advanced vape kit.
With these coils larger amounts of vapour will be created, to support this we recommend you use e-liquids that are 60% VG or higher. Due to the larger amounts of vapour that is created, we advise that you do not use an e-liquid that has higher than a 6mg nicotine strength.
Registered members earn £0.50 in loyalty points for every published product review!
By Johhnyp from Brighton
Tried these on the off chance and wow was I happy!
I had given up on my cloud beast as it just wasn't doing what I wanted but these changed all that. I am using it at 100w on the SMOK Alien with Ruthless Grape Drank I may never use any other combo. 7 days use and amazing clouds and flavor.
By Grey fox from Surrey
i grabbed one of those pre made coils when they first came out and had to try it
i must admit i was quite suprised by the flavour and cloud production
i was vaping this beast at 80 watts and that was more than enough, it produced a warm but tasteful vape
so the coils in here are parallel coils sided by side with another set on top which give you your 4 vertical coils
if you haven't tried those i would go for it, they chuck the cloud and the vapour once that break in period of a tank is done, when priming those i tend to prime the cotton around the coil and put a couple of drops on the coils them selves, once youve done that youre ready to rock
i will probably grab a couple more as a go to when i need to change my RBA section coils
the threads are a bit ganky but once they are in its fine, it wont knacker the thread on your bottom plate either