From £8.99
The Uwell Valyrian 2 UN2 coils have been designed for use with the Valyrian 2 tank and Valyrian 2 kit only. There are four versions of this coil available, all of which have been designed for sub ohm vaping.
Features:
The 0.32 Ohm UN2 coil features a single mesh coil build and has been built to maximise airflow. This coil can be used between 90 - 100W and the mesh has a larger surface area to heat more eliquid at a faster rate.
The 0.14 Ohm UN2 coil utilises two mesh coil builds and has been created for enhanced cloud production. This coil can be used between 80 - 90W and the two mesh coil help create better flavour.
The 0.16 Ohm UN2 coil features a triple mesh coil build and has been manufactured to deliver better flavour from your eliquids. Designed for use between 90-100W you’ll also experience increased vapour production.
The 0.15 Ohm UN2 coil uses standard wound coils and features a quadruple coil build. This coil offers a balance of flavour and cloud and can be used up to 120W.
Contains:
Important information about sub ohm vaping:
Any coil that registers below 1.0 Ohm, is known as a sub ohm coil. Recommended for advanced vapers only, they'll require more power to use properly, which will be provided by an advanced vape kit.
With these coils larger amounts of vapour will be created, to support this we recommend you use e-liquids that are 60% VG or higher. Due to the larger amounts of vapour that is created, we advise that you do not use an e-liquid that has higher than a 6mg nicotine strength.
Do you have a question about this product? Why not ask our expert team.
By Mark from Carterton
When it doesn't leak it's an excellent coil, big clouds and great flavour. However i've used both the single and dual mesh coils and both have leaked immediately after filling, it's almost like every other coil. You only get two coils in the pack and it's seems Uwell package them as one good and one bad coil. £8.99 is expensive for only two coils, plus whatever you're paying in wasted liquid! The Valyrian 2 kit is great mod and tank, it's just a shame it's let down by a shoddy coil.
By Arius from Hungary
- 1 mesh coil - It has superb airflow, and its durable. I could use it for 3 weeks without a hint of burn on the cotton. The flavour intensity is 8/10, the clouds is 8/10, the airflow is 9/10.
- 2 mesh coil - The airflow is still super, the flavour is a bit better. Flavor intensity 9/10, clouds 8/10 airflow 8/10.
- 3 mesh coil - As I wrote earlier the durability is not as good as its brothers, but its still ok on other aspects. Flavor intensity 9/10, clouds 8/10 airflow 7/10.
By Arius from Hungary
I used it for maybe 1 week and had to replace it beacuse it got burnt, and the taste reflected it. It can by my fault, or the liquids, but still it expired sooner than the one mesh version.
By Arius from Hungary
It was hard to replace, but was achivable. Be ready with paper towels, beacuse you will want to clean the parts.
Compared to the single mesh version, it has a bit less airflow, and a bit more taste. I can use it with the same 85-105 W povercurve mode, and compared to the single mesh version, it creates - hardly managable - bubles in the tank less frequently, it absorbs the liquid more evenly.
I enjoy this atimizer, but I don't know If I will pay the extra, or just use the single/dual mesh cheaper.