| Coil Resistance | 0.8ohm, 1.0ohm |
|---|---|
| Coil Types | Mesh |
| Made In | China |
| Pack Size | 4 Pack |
| Pod Coil Type | Mesh |
| Tank Capacity | 2ml |
£9.99
The Uwell Caliburn A3S pods are designed to be used with the Caliburn A3S and Caliburn A3 pod kits and can hold up to 2ml of e-liquid. The built-in coils deliver a small amount of vapour for an MTL (Mouth To Lung) inhale and mean that there are no messy coil changes to worry about – just replace the whole pod when a coil runs out.
Features:
Refilling is easy thanks to the side filling design – all you need to do is remove the stopper to access the fill port. Two resistances are available: 0.8 Ohm, which will provide a slightly airier vape; and 1.0 Ohm, which will provide a more restricted inhale. Both allow for an MTL inhale and feature mesh construction for enhanced flavour. This pod works best when combined with e-liquid that’s at least 50% PG, and works well with either freebase or nic salt vape liquid.
Contains:
(387)
(117)
(18)
(20)
Do you have a question about this product? Why not ask our expert team.
By Ells
always chose this style over the over ones as i find them easier to refill and are slightly cheaper, on rare occasion have they leaked for me, i found the other ones leaked quite a fair bit
By Cheryl from Wales
These pods are very convenient and easy to refill and replace but I’ve had some experiences where they leak. Other than this they’re great.
By Snowfish
Have been using these for 6 months now. Great pod kit, last a good time and deliver a good flavour. Cost effective. Better battery life on the actual device is the only bugbear. Can leak slightly if left
By Cal from London
Great, easy to fill pods - produce good flavour - i have had a little leaking with mine though.
By Puff
I've only recently purchased my A3S. However, I'm still using the pods that came with the kit. Ordered some more just to have some replacements ready to go.
They're really great pods that produce great flavours and clouds. Haven't had any leak yet, and they seem to last ages, too.
By Mark DH
Not much in it between these and the A3 pods. Both give off great flavour. This one seems a little less prone to leaks but filling can be a bit fiddly.
By J from UK
These are generally easy to fill, you just need to refine your technique (which you'll do over time). Prefer the 0.8's over the 1.0's, would buy again.
By Ahu381 from London
These are by far the best pods I've experienced. By having the coil integrated into the pod and with side-filling, they don't leak like the G2 coils do. Furthermore, the plastic is slightly frosted which means that they don't smudge or attract any 'lip crud' and are easy to clean with a simple wipe. They produce a great tasting vape (like the G2 coils), especially after a few refills and for me I have been able to get through 10-12ml before needing to replace it. Definately prefer the 0.8ohm coil over the 1.0 as it is warmer and produces a denser cloud, but it does drain the battery a bit quicker. Finally, they are good value for £9.99 for a pack of 4, which is a similar price to the G2 coils alone!
By LJC from Watford
Smashed it, I've had a few boxes of both ohm styles and both are great.
The 1.0 ohm works so nice with a 50/50 20mg nic, just the right amount of warmth and a fairly tight mtl draw yet still lots of vapor production and really really good flavor!
The 0.8 ohm works great to both 50/50 and 60/40 nic salt. Pretty sure you'd get away with a 70/30 if the nic level is low and you used it as mtl and didn't pull too hard. You can surprisingly do a very very tight dtl but is definitely not designed for it. The airflow is super open on this pod and you'll feel a nice loose mtl draw but can catch the throat abit with certain juices..
Overall the 0.8 are most impressive while the 1.0 are more traditional caliburn feel to the draw
Both have surpassed the G2 coils and the A2 pods massive improvement. Personally much prefer the side fill also
By Nath from West Midlands
Decent cheaper alternative to the A3 pods. Still prefer the top fill as the side fill rubber is more of a pain to get open compared to the top cap on the A3 (just my preference) but you can certainly get more juice into these as they allow filling up inside the cap area.
Had one leak but that was down to me squeezing out a flavour I wasn't keen on, so just be aware.
