The GeekVape Ammit MTL RDA is a small 22mm RDA (Rebuildable Dripping Atomiser) that has been designed for mouth to lung vaping.
Recommended for advanced users, it features Stainless Steel construction and unique airflow structure for enhanced taste. It can be used with a range of vape mods providing they have a 510 connection.
The small size of the chamber has been designed to allow this RDA to generate a greater amount of flavour. This is further enhanced by the Stainless Steel construction which makes the Ammit both durable but helps provide a clean taste.
The two post clamp deck while small still leaves ample room to fit your rebuildable coil. The Ammit supports single coil builds only for a mouth to lung vape. The juice well allows for a good flow of eliquid, ensuring your cotton wicks stay saturated.
The unique top airflow structure allows for an increased flow of vapour, while still providing a restricted inhale, helping you get the best flavour from your eliquids. The airflow is fully adjustable allowing you to configure it to your choosing.
Designed to be used with a range of vape mods and devices, the Ammit comes pre-fitted with a 510 pin. It is also squonk compatible with a BF Pin included with the kit, allowing you to use this RDA with bottom-feeding devices.
Important information about Rebuildable Dripping Atomisers:
This product is designed for experienced users, and for those possessing an ohms reader or multimeter to test their coils on. This device requires a comprehensive understanding of the technicalities of vaping, along with knowledge of electronics and Ohm's law.
We don't advise any beginners to start rebuilding coils without speaking to a knowledgeable shop. A rebuildable coil must be tested carefully on an Ohms reader before it is used on a device. Not testing this properly may present a safety risk for the user, and no new coils should be used on an electronic vaping device until the coil is known to be safe.
There are currently no customer reviews avaiable for this product.