The GeekVape Tengu RDA has been designed to offer a smoother vape with enhanced flavour, Its three post deck will support dual coil builds. You can use the Tengu with a range of mods thanks to the option of the standard 510 pin and squonk pin, that's included with each RDA.
A unique dual airflow construction ensures a consistent flow of vapour, delivering a purer taste from your eliquids. The height of the airflow means it will sit parallel to your coils, ensuring a cool vape, as well the raised height also helps to prevent leaking.
The three post build deck has been created to offer a simple solution to fit coils. This design means that you will not have to pre-trim you coils, just install them and cut away any excess afterwards. The large terminal holes enable to install even the more exotic coil types.
The Tengu can be paired with your favourite vape mod, thanks to its 510 connection. For those of you who enjoy squonking. By installing the BF pin included with each RDA you’ll end up with a squonk compatible atomiser. In both modes, the deck ensures an even flow of eliquid.
Important information about Rebuildable Dripping Atomisers:
This product is designed for experienced users, and for those possessing an ohms reader or multimeter to test their coils on. This device requires a comprehensive understanding of the technicalities of vaping, along with knowledge of electronics and Ohm's law.
We don't advise any beginners to start rebuilding coils without speaking to a knowledgeable shop. A rebuildable coil must be tested carefully on an Ohms reader before it is used on a device. Not testing this properly may present a safety risk for the user, and no new coils should be used on an electronic vaping device until the coil is known to be safe.
Registered members earn £0.50 in loyalty points for every published product review!
By Ian from Essex
I got this after using the Hellvape Dead Rabbit RDA. The Tengu is so easy to build on, no pre cutting coils due to the side mounted approach, slide them in, clip the ends, wick and you're ready to go!
Dripping with this is superb also, the middle pointed section ensures even distribution when dripping and the deck has enough of a well to tuck into and allow for this RDA to be put onto a squonk mod.
Using the GeekVape Cotton with the Tengu RDA produced some amazing flavour and clouds when using my daily ASAP Grape from Nasty Juice.
Highly recommended! and a great price from Vape Club.
By Giles from Sussex
It's a nice device. High quality build, and very easy. It's just doesn't have as much to offer as the drop, or the recurve. It's a decent dual coil for the collection, a little outdated though.