Hellvape Hellbeast 24mm RDA

The HellVape HellBeast RDA has been developed to offer the best flavour possible from e-liquid. Offering plenty of options for customisation, it features a four-post build deck and is compatible with dual coil builds. Capable of supporting both MTL (Mouth To Lung) and DTL (Direct To Lung) vaping, it features an advanced airflow design that allows you to discover your perfect inhale. Thanks to the option of both a 510 pin and hollow BF (Bottom Feeding) pin it can be paired with a range of vape mods, including squonk mods.

Features:

• 24mm RDA
• Four Post Drop Deck
• Supports Dual Coil Builds
• Adjustable 72-Hole Airflow
• Squonk Compatible
• 510 & BF Pin Included

The four-post build deck means that not only can you pair the HellBeast with a wide range of rebuildable coils, but also the set-up is very quick. You can drop coils straight into the deck and then trim away any excess. Alternatively, use the cutting tool included and you’ll end up with the perfect size coil that you can install and use. Thanks to gold-plating on the deck heat will reach the coils quicker for a faster ramp-up, plus there's plenty of room for cotton wicks.

What really sets this RDA apart is the airflow. The Trinity stepped airflow allows for exact configuration to deliver your perfect inhale. With 72 airflow holes, the grid-style design stops spitback and helps generate better flavour and a warmer vape. Close the airflow and use high resistance coils and you’ll experience a tight MTL inhale, while opening it and using low resistance coils delivers a classic, airy DTL inhale.

Contains:

• HellVape HellBeast RDA
• 510 Pin (Pre-Installed)
• BF Pin
• 2 x Shoelace Cotton Wicks
• 2 x NiChrome 0.37 Ohm Pre-Built Coils
• Coil Cutting Tool
• User Manual

Important information about Rebuildable Dripping Atomisers:

Rebuildable atomisers are recommended only for experienced users. You should have the knowledge and access to the equipment that is required to set up this atomiser properly.

Before building or using an RDA you should have a thorough knowledge of battery safety, Ohm's Law and vaping in general.

Before fitting a coil onto your rebuildable atomiser ensure it is in a safe condition and registering the correct Ohmage, this testing and checking can be achieved by using a dedicated Ohmmeter. Coils should not be tested on vape devices.