dotMod 24mm V1.5 DotRDA

The DotMod 24mm DotRDA V1.5 is a high-end Rebuildable Dripping Atomiser that we recommend to advanced vapers. Featuring a unique build deck design, it’s compatible with dual rebuildable coils and will create large amounts of vapour. Each RDA comes with a 510 standard connection pin and a hollow BF (Bottom Feeding) pin. This means it can be paired with both standard vape devices and squonk devices.

Features:

• DotMod RDA
• Spring Loaded Clamp Deck
• Support Two Rebuildable Coils
• Combination Ceramic / Gold-Plated Deck
• Adjustable Dual Airflow
• Squonk Compatible

As you'd expect from DotMod, this RDA uses high-end materials to create a stylish, functional and hardwearing rebuildable atomiser. The newly designed anodised top cap helps promote a purer flavour as it has a lower profile, meaning vapour has less of a way to travel. The dual airflow on this RDA is fully adjustable and can be used to increase or decrease the flow of vapour you'll experience.

The spring-loaded clamp deck makes fitting dual coil builds a very quick task, as you aren't required to pre-trim the wire before installation. The deck features both ceramic plates and gold-plating, which means a more concentrated flow of heat for a faster ramp-up and a more consistent vape overall. The dual adjustable airflow sits parallel to your coils and ensures a constant flow of air for enhanced vapour production.

Overall, the DotRDA is a high-end piece of vape hardware that is versatile and capable of producing large clouds and flavour to match.

Contains:

• 1 x 24mm DotRDA
• 1 x Spares Kit
• 1 x 510 Pin (preinstalled)
• 1 x BF Pin
• 2 x Prebuilt Coils

Important information about Rebuildable Dripping Atomisers:

Rebuildable atomisers are recommended only for experienced users. You should have the knowledge and access to the equipment that is required to set up this atomiser properly.

Before building or using an RDA you should have a thorough knowledge of battery safety, Ohm's Law and vaping in general.

Before fitting a coil onto your rebuildable atomiser ensure it is in a safe condition and registering the correct Ohmage, this testing and checking can be achieved by using a dedicated Ohmmeter. Coils should not be tested on vape devices.